Search what-is-the-radius-of-the-circular-path

What is the radius of the circular path

 
 

Top Questions

1.A skier starts from rest at the top of a hill. The skier coasts down the hill and up a ...

as the drawing illustrates. The crest of the second hill is circular, with a radius of 28.6m. Neglect friction and air resistance. What must be the height of the first hill so that the skier just loses contact with the snow at the crest of the second hill?
View More

2.Q1) (15 points) In the diagram below, M1 = 50 Kg, M2 = 20 Kg, mass and radius of the ...

g and 30 cm each, respectively. Both M1 and M2 rest on frictionless surfaces and the system starts from rest. (a) Draw the fbd for each of M1, M2 and the pulley. (b) Write the equations of motion for each of M1, M2 and the pulley. (c) Calculate the linear acceleration of the two masses, as well as the angular acceleration of the pulley. (d) Calculate the angular velocity of the pulley after M1 and M2 have been displaced linearly by 2 m. Q2) (10 points) A basketball is thrown with an initial speed v0 of 10.8 m/s at 400 above horizontal, and it enters the hoop from above. The ball is released at 2.00 m above the ground. The hoop is 3.05 m above the ground and 10.0 m away from the player. (a) Find the time at which the ball passes through the hoop. (b) Find the ball’s velocity (express in component form) just when it enters the hoop. (c) Find the ball’s maximum height. Q3) (5 Points) An object is thrown up from the top of a building of height of 400 m with an initial velocity of 20 m/s. (a) Find the position and the velocity of the object 5 s later. (b) With what velocity will it hit the ground? (c) At the same time the first object is thrown up, a second object is thrown up from the ground at 100 m/s. Will the two objects collide? If yes, calculate when and where,
View More

3.A rock weighs 105 N on the surface of planet X with gx= 21.2 ms2 . What is the weight ...

the surface of planet Y, which has 29 times the mass and 3.6 times the radius of planet X?
View More

5.I am trying to figure out the optimal radius that will give the lowest surface area of a cylinder. I ...

have done the calculus which reveals that the surface area is at a minimum when height is double the radius. I am now trying to find an equation for the relationship between the amount of wasted surface area as a percentage of the minimum surface area and the ratio between height and radius. If I were to plot it on a graph, the y axis would be the percentage of excess materials needed as a percentage of the minimum possible surface area, and the x axis would be height divided by radius. Since the surface area is minimized when height=2(radius), I know that when x=2, y=0. The website https://www.datagenetics.com/blog/august12014/index.html explains what I am trying to do quite well and shows the graph below. I am trying to find the equation for this graph, but am unsure how to go about it.
View More

7.1) Which of the following statements about scientific methods / theories is correct? (1/0/0) a) A scientific theory must be able to ...

a) A scientific theory must be able to be proven. b) A scientific theory has been derived from known facts and always applies. c) A scientific method should give different results depending on who performs the method. d) Knowledge of our surroundings usually emerges through an interplay between theory and experiment. 2) The sides of a straight block are measured to 3,202 cm; 0.0012 cm and 11.2 cm, respectively. Calculate the volume of the straightening block and enter it with the correct number of value digits. (2/0/0) Number of words: 0 3) A 9.2 dm long and evenly thick rod rests on a support. 0.55 dm from one end, a dynamometer is hung so that the rod will hang horizontally. Then the dynamometer shows 4.4 N. How much does the bar weigh? (1/1/0) Number of words: 0 4) A bar AB that is homogeneous and evenly thick has a length of 2.70 m and is rotatable about an axis at A. The bar weighs 25 kg and is kept in equilibrium by a force F which has its point of attack in B. is 45 degrees. How big is the force F? (1/1/0) Saved! 25 * 9.82 = 245.5 N Number of words: 6 5) A trolley rolls at a constant speed to the right. On the cart is an upward cannon that suddenly shoots a bullet. The carriage continues to the right with the same speed as before. Where does the bullet end up when it falls? For a detailed reasoning. (1/1/1) Number of words: 0 6) A river is 200 m wide. The water in the river flows at a speed of 2.5 m / s. A motorboat steers across the river at its maximum speed, which in stagnant water is 5.0 m / s. The boat is constantly heading perpendicular to the banks of the river. Where does the motorboat land on the other shore? (2/0/0) Number of words: 0 7) A ball with a mass of 2.0 hg moves at a constant speed in a circular path. The radius of the track is 1.5 m and it takes the ball 3.0 seconds to move one turn. How big is the centripetal force? (1/1/0) Number of words: 0 8) A bullet moves at a constant speed. Can we then safely say that the resultant of the forces acting on the bullet is zero? Motivate and discuss your answer. (0/1/1) Number of words: 0 9) A conductor is located between the poles of a permanent magnet. The current in the conductor goes in the direction of the plane of the paper (away from the reader). How is the force acting on the leader directed? (1/0/0) a) To the right of the figure b) To the left in the figure c) Downwards in the figure d) Upwards in the figure 10) Protons enter horizontally from the left between two large metal plates at a speed v = 0.80 Mm / s. The plates are connected to a voltage source with the pole voltage U. Between the plates there is a homogeneous magnetic field with a flux density of 38 mT directed perpendicular to the plane of the paper. The distance between the plates is 1.5 cm. They want the protons to continue with unchanged direction and speed between the plates. Which of the plates should be connected to the positive pole of the voltage source and how large should the voltage U be? (0/2/0) Number of words: 0 11) The magnetic flux Φ through a 700-speed coil decreases linearly with time according to the diagram below. Calculate the voltage across the coil at time t = 1.0 ms. 12) The current in a coil with an inductance of 35 mH has a growth rate of 6.2 A / s at a given moment. What is the instantaneous value of the ems induced in the coil?
View More

1.AU MAT 120 Systems of Linear Equations and Inequalities Discussion

mathematicsalgebra Physics